Page 1 of 1

Cabinet Index

Posted: Wed Nov 21, 2018 6:05 am
by analogj
Hi,

I'm trying to use FUSE mounting to backup my Mayan EDMS documents with my cabinet structure.
From what I've read, the FUSE mounting only works on Indexes, and I havent been able to figure out how to create a Cabinet Index

Thanks!

Re: Cabinet Index

Posted: Thu Nov 29, 2018 8:20 pm
by FlightdeckRob
You could always just make an index that mirrors your cabinet and then mount the index? It means a redundant index but would get you what you want.

Re: Cabinet Index

Posted: Wed Dec 05, 2018 5:27 pm
by analogj
FlightdeckRob wrote:
Thu Nov 29, 2018 8:20 pm
You could always just make an index that mirrors your cabinet and then mount the index? It means a redundant index but would get you what you want.
Thats actually exactly what I want to do, but unfortunately I cant figure out how to create a new index that follows the cabinet structure.

Code: Select all

Cabinet Index
- Cabinet 1 name
   - Document 1 name 
   - Document 2 name
- Cabinet 2 name
    - Document 1 name
Basically since Documents can be in multiple cabinets, I'm a bit thrown.

Any ideas?

Re: Cabinet Index

Posted: Thu Dec 06, 2018 1:13 pm
by FlightdeckRob
I'm no expert on this but I would think that if you created 1 index per cabinet and then mounted each index with FUSE you would have a folder structure similar to what you're looking for.

There may be a way to do it with a single index (and I think there is) but without a list of variables I haven't been able to figure it out.